We propose the single feeder fiber architecture for wavelength division multiplexing passive optical network (WDM-PON) based on directly modulated chirp managed laser (CML). The downlink (DL) signal output from the laser is converted to return-to-zero (RZ) differential phase shift signal using a pulse carver. The downstream signal is reused as a carrier for the upstream using intensity modulation technique. Simulation results show the error-free performance at symmetric data rate of 10 Gbit/s per channel with negligible power penalty and improved receiver sensitivity for the uplink (UL), over 25 km standard single-mode fiber (SSMF). A low-cost and reduced circuitry network design is implemented on a single feeder fiber with the elimination of differential encoder and one external modulator.

In order to achieve higher spectral efficiency, mode division multiplexing (MDM) in few-mode fibers is a new research area. The idea faces lots of technical issues including intermodal delay and mode coupling which limit the achievable length of the system. This paper is designated to complete the analysis of intermodal delay in step-index few-mode fibers. We analyze numerically all the parameters of fiber, which could impact intermodal delay in few-mode fibers and identify the conditions which can increase the number of multiplex modes without significant increase in maximum intermodal delay.

We experimentally demonstrate and analyze a 10 Gbit/s full duplex wavelength division multiplexing passive optical network (WDM-PON) system. A non-return-to-zero differential phase shift keying (NRZ-DPSK) modulation technique is first utilized for downlink direction, and then the downlink signal is re-modulated for the uplink direction using intensity modulation technique of on-off keying (OOK) with a data rate of 10 Gbit/s per channel. An effective colorless WDM-PON full duplex transmission system is achieved for the data rate of 10 Gbit/s per channel with a channel spacing of 60 GHz over the distance of 25 km with low power penalty.